Our Terms & Conditions can be found at www.loynds.com alternatively we can send them to you by e-mail on request.

Any Goods Supplied Remain The Property Of The Seller Until They Are Paid For In Full.

Bankers: National Westminster Bank, Fishergate, Preston. Reg. Office: 9 Chapel Street, Poulton-Le-Fylde. FY6 7BQ

Company Reg. No: 1722928 V.A.T. 534 5020 78

!

Simple instruction Manual for the use of the Loynds drop roller machine.

Warning: The machine can be of a dangerous nature so please make sure the guards are fitted at all times, keep

fingers and clothing away from the machine. Always use with caution.

Removing the rollers. Remove the guarding, undo the two bolts on the top of the two roller bearing support

units, then remove the brass bearings blocks that centre the rollers, the infeed and outfeed slides should be

When the machine is ready for production please proceed as follows:-

Make sure the rollers are evenly on top of each other, tighten the rollers down with the thumb screws, do not

over tighten these, just make sure the rollers are evenly touching and are a little more than finger tight

Prepare a piece of candy into a flat sheet a little less wide than the forming rollers and just a little thicker than

the impressions on the rollers. Then with the machine turned on feed the candy into the infeed side of the

rollers, once the rollers get hold of the candy the rollers will pull in the candy, on the outfeed of the machine a

sheet of candies will exit from the machine, once the sheet of candy is passed through the machine the process

Once the candies have hardened you need to break them up, if doing this by hand gather the candies together

and shuffle them around with gloved hands, this will break up the thin webbing that joins the candies together,

rubbing the candies together will remove most of the burrs and rough edges around the candy, after this process

is complete sieve the candies in a sieve to remove the unwanted webbing and be left with nicely formed

candies.

The machine is a simple machine. It only requires basic maintenance that when the rollers are removed for

cleaning that the gears are lightly greased or oiled, the brass bearings where the rollers run should also be

lightly greased. The drive chain should be oiled approximately every three months.

Our Terms & Conditions can be found at www.loynds.com alternatively we can send them to you by e-mail on request.

Any Goods Supplied Remain The Property Of The Seller Until They Are Paid For In Full.

Bankers: National Westminster Bank, Fishergate, Preston. Reg. Office: 9 Chapel Street, Poulton-Le-Fylde. FY6 7BQ

Company Reg. No: 1722928 V.A.T. 534 5020 78

Make sure the candy strip to go through the machine is the correct thickness and width, to thin and the candy

Videos showing a drop roller working:-

http://www.youtube.com/watch?v=-F1Ab9q1IRk&feature=relmfu

http://www.youtube.com/watch?v=aSE1bx3q8Bc&feature=relmfu

!