OPERATING THE MEGASTAR HOVERBOARD
STEP 1 - Charging Your Megastar Hoverboard
Make sure the Megastar hoverboard is fully charged before your initial use. For charging instructions, please follow
details in CHARGING THE BATTERY - PAGE 6.
STEP 2 - Getting Started
Place your Megastar hoverboard flat on the floor. Press and
hold the power button for 1 second, located on the back of your
Megastar hoverboard on the right side. The battery indicator
light should be lit, indicating the device is powered on.
STEP 3 - Checking The Display Board
Located in the centre of your Megastar hoverboard,
the battery power level indicator light should be lit,
indicating there is power to the device.
A. Battery Power Level Indicator:
The display board is located in the middle of the
Megastar hoverboard. The green LED light indicates
the Megastar hoverboard is fully charged. When the
battery level is lower than 30%, the indicator light will
flash in green slowly. When the battery level is lower
than 10%, the indicator light will flash in green rapidly
and raise an alarm.
B. Balance Level Indicator: When the user triggers the foot platforms, the balance level indicator LED will light
up, which means that the system enters the running state; when the system has an error during operation, the
balance level green LED light will turn flash and you will hear the system alert you with a beep.
STEP 4 - Safety Gear
Wear proper safety gear, including, but not limited to a
helmet, knee pads, elbow pads, and wrist guards.
STEP 5 - Standing On
A. Stand directly behind your Megastar hoverboard.
Place one foot on the foot platform, keeping the instep
of your foot on the outer edge of the board.
B. Keep all your weight on your back foot still on the
ground. Otherwise, your device will begin to move,
making it difficult to step on evenly with your other foot.
Balance
Level Indicator
Battery Power
Level Indicator
Helmet
Elbow Pads
Wrist Guards
Knee Pads
Calibrating The Board:
If the Megastar hoverboard moves forwards or backwards on its own on flat ground it needs to be calibrated.
- Make sure the power is OFF and place it on a flat horizontal surface, ensuring the footplates are 100% level.
Use a spirit level if necessary.
- Once you are happy the board is level, press the power button for 5 seconds. In this period, the left green
LED (Balance Level Indicator) will flash and the system will start to calibrate automatically.
- Once complete you will hear 3 beeps and then release the power button.
- Switch the power OFF then ON again before use.
Calibration may need to be repeated when the two foot platforms are uneven or the hoverboard is out of balance.
We recommend calibrating your hoverboard regularly.
Self-balancing Mode:
When the hoverboard is in this mode, it will level itself on flat ground,
making it easier to step on.The default setting of this function is ON,
the user can follow below steps to switch off this function.
1. Make sure the power is switched ON.
2. Press the power button for 5 seconds until you hear 3 beeps,
the process is completed.
Note: If you restart the Megastar hoverboard, the self-balancing
function will turn on again.
Keep one foot steady before
stepping both feet on hoverboard
7
Colourful LED
lights
Need Help? Visit our website for replacement parts and product support WWW.ZINCSPORTS.COM
Contact us at
[email protected] OR CALL
OUR CUSTOMER SER
VICE LINE ON +44(0) 800 731 0006
Charging Pin Port
Power Button
Remark: The hoverboard will turn off automatically if it has not
been used for 10 minutes. You need to restart it by pressing the power button for 1 second.