2/5 ITB14-011G
Supplemental RES Service Information
Operate RES as instructed below to verify if the system is working properly.
1. Start the engine with the push-button ignition switch.
2. Turn the ignition OFF, and then wait six (6) seconds.
3. Exit the vehicle, make sure all doors are closed, and then lock the vehicle with the Intelligent Key.
4. Within five (5) seconds of pressing the LOCK button, point the Intelligent Key at the vehicle, and then press
and hold the RES button until the turn signal lights flash and the parking lights turn ON.
The engine should start, the parking lights should remain ON, and the doors should remain locked
while the engine is running.
o If the above conditions do not occur, use the Supplemental Diagnosis Table below in addition to
the ESM.
Supplemental Diagnosis Table
The engine
does not start
using the RES
feature
(see steps
1-4, above)
Possible Cause Confirmation of Cause Resolution
1
ECM has not
completed the shutdown
procedure after
engine/ignition OFF.
ECM has to end the
shutdown process and save
data prior to allowing RES to
operate. The shutdown
process takes six (6) seconds
to complete after the
engine/ignition is turned OFF.
Wait six (6) seconds after the
engine has stopped before
attempting RES activation.
2
RES is correctly activated
more than two (2) times
consecutively
OR
RES is activated once, and
with the engine running,
another request is generated.
Not possible to confirm how
many times RES has been
activated.
Perform steps 1-4, above.
This action will reset the
counter.
3
One or more Intelligent Keys
for the vehicle are still inside
the vehicle.
With all known Intelligent
Keys outside and out of
range of the vehicle, try to
turn ON the ignition with
push-button ignition switch.
If the ignition turns ON, at
least one Intelligent Key is
inside the vehicle.
Find and remove all
remaining Intelligent Keys
from the vehicle, lock doors
with the Intelligent Key, and
then perform RES.